Base Tube
This peice will run the length of the entire saber, acting as a base for
the other tube sections.
Take your 1-1/4" x 12" extension tube. The cap is not needed, but the
washer will be used later.
Cut a section off the non-threaded end so that the overall length of the
tube is 11-3/16". The flared section of this tube will need to fit
securely and flush inside the flared section of the emitter tube section.
To make this possible you should use a sanding drum on the rotary tool
and grind down the threads on the base tube.
It may take a little while to get the threads ground down, but it will
eventually fit perfectly in to the emitter tube section.
Home Style
#2 Parts List
Emitter Tube Base
Tube Grip Tube
Pommel Tube Clip
Knob Emitter Assembly
Grip Assembly Pommel
Assembly Finishing
Touches Email
Me